Symmetry EN-7500 Series
EN-7510 Installation Guide
9600-0541 Issue 1.1
Page 9 of 23
4. INSTALLATION
4.1. Installing a C/CS Mounting lens
1. Remove the protective rubber cap from the front of the camera.
2. Install the mount ring for lens and adjust the mount ring to fit C or CS lens.
3. Tighten the set screws using the hex wrench supplied with the camera.
4.2. Installing an Auto IRIS lens
1. Remove the cover of the auto iris lens plug and connect it with the lens cable.
2. Connect the auto iris lens plug to the 4-pin lens terminal on the back of the camera.
Note
i
Use the connection recommended by the manufacturer. For best
performance, read the lens manual carefully. You may need to set the
flange back focus.
Note
i
Only DC-drive type is supported.
CW
SET SCREW
Set Screw
(For IRIS LENS)
CCW
CW
