APEX-SYMAC Series
Installation Instructions
8
Using Grommet Hardware
1.
Remove desk clamp from mount by loosening button head
cap screw until clamp is completely disengaged from the
bolt. (See Figure 5)
2.
Maneuver clamp so that it is totally removed from desk
mount. (See Figure 5)
NOTE:
Set removed washer aside for re-use.
Figure 5
3.
Locate a flat surface (thickness of 3/4” minimum to 3 1/2”
maximum) on which to mount the column plate.
4.
If mounting hole does not already exist on desk, drill 3/8”
mounting hole in desk at desired mounting location.
IMPORTANT ! :
Mounting hole must be between 3/8”
and 2 1/2” in diameter!
5.
Place mount on desk over grommet hole. (See Figure 6)
6.
Use 5/16-18 x 6” button head cap screw (H), removed
washer, clamp bracket (F) and 5/16-18” square nut (G) to
secure mount to desk. (See Figure 6)
Figure 6
Array Installation (APEX-SYMAC2D ONLY)
1.
Slide rotational spacer (J10) into opening on array
attachment bracket. (See Figure 7)
2.
Use 5/16-18 x 3" button head cap screw (J3), two thin steel
washers (J8), plastic spacer (J9), pocket washer (J5), pivot
pin (J4), pivot point spacer (J12) and 5/16-18 lock nut (J6)
to secure array (J1) to mounting arm (A). (See Figure 7)
NOTE:
Cable clip (J11) can be used in place of pivot point
spacer (J12) if additional cable management is desired.
(See Figure 7)
Figure 7
2
1
(F)
(G)
(H)
6
removed washer
(J10)
1
(J3)
2
(J9)
(J8) x 2
(J5)
(J1)
(J4)
(J6)
(A)
or
(J12)
(J11)
