140
TimeProvider 500 2.0 User’s Guide
098-00172-000 Revision A – December, 2009
Chapter 6
Factory Defaults
Factory Defaults
provides general and communication default values.
Table 6-13. General and Communication Parameters
Description
Default Value
Value Range
Alarm Delay
3 seconds
0–86400 seconds
Alarm State
Enabled
Enable | Disable
Announce Interval
1 second
1, 2, 4, 8 second(s)
Bridge Time
420 seconds
120–86400 seconds
Domain 0
0–255
DSCP
0
0–63
EIA-232 Port
57.6k-8-N-1
Baud rate range:
4800 | 9600 | 19200 | 38400 | 57600
Firewall
Allowed for telnet / ICMP
Allowed | Blocked
Freerun Output
ON
{ ais | on | squelch }
Gateway Address
0.0.0.0
Valid IPv4 Address
GM1 IP Address
192.168.1.11
Valid IPv4 Address
GM2 IP Address
0.0.0.0
Valid IPv4 Address
HDB3
Enabled
Enable | Disable
Holdover Output
ON
{ ais | on | squelch }
IP Address
192.168.1.9 (non-VLAN)
Valid IPv4 address
IP Mode
Static
DHCP | Static
Lease Duration
300 seconds
10–3000 seconds
Network Mask
255.255.255.0
Valid IPv4 Mask
PTP State
Enabled
Enable | Disable
PPS Offset
2894 ns
-1,000,000 –+1,000,000 ns
PPS Width
100,000,000 ns, 500 ns
is the default for
090-03863-01 hardware.
100–500,000,000 in steps of 1 ns
Signal Type (OUT1)
clk_2048
[1pps | clk_2048 | e1_cas | e1_cas4 |
e1_ccs | e1_ccs4 | e1_ais| t1_sf | t1_esf |
clk_1544 | t1_iso_pulse]
Summary of Contents for TimeProvider 500
Page 10: ...Table of Contents 10 TimeProvider 500 2 0 User s Guide 098 00172 000 Revision A December 2009 ...
Page 12: ...List of Figures 12 TimeProvider 500 2 0 User s Guide 098 00172 000 Revision A December 2009 ...
Page 146: ...146 TimeProvider 500 2 0 User s Guide 098 00172 000 Revision A December 2009 T1 Format ...
Page 174: ...Index W W 174 TimeProvider 500 2 0 User s Guide 098 00172 000 Revision A December 2009 ...
