Chapter 2 Configuring Your 59552A/59553A
Configuring for Two-Signal Distribution (Combined Mode Operation)
2-20
User’s Guide
Configuring the 59553A for Combined Mode Operation
1
If you need to set the
rising edge
of the 1 PPS output to correspond
with on-time edge (system output is a positive pulse), place jumper P3
in its pins 1,2 default position as shown in Figure 2-11.
If you need to set the
falling edge
of the 1 PPS output to correspond
with on-time edge (system output is a negative pulse), place jumper P3
in its pins 2,3 position.
2
Place jumper P4 in the pins 1,2 position to select two-signal
transmission as shown in Figure 2-11.
Figure 2-11. 59553A Combined Mode Jumper Locations
3
Re-install the cover by performing the cover removal procedure in
reverse.
4
Now, connect the units as shown in Figure 2-12.
This completes the Two-Signal Distribution (Combined Mode
Operation) configuration procedure.
1 to 2 +PULSE
2 to 3 -PULSE
1 to 2 PULSE
2 to 3 DIGITAL
P3
P4
3
2
1
3
2
1
U R
COMPONENT TYPE
CUSTOM RECTIFIER
LR85805
LEVEL 3
Ba
uart
g
e p r u
f t
TUV
E131905
1 to 2 +PULSE
2 to 3 -PULSE
P3
P4
3
2
1
1 to 2 PULSE
2 to 3 DIGITAL
3
2
1
Summary of Contents for 59552A
