www.symetrix.co
| +1.425.778.7728
PN 53-0082 Rev C 02/22
2 of 3
QUICK START GUIDE:
AEC Coprocessor Module
ESD Warning
This product can be damaged by electrostatic discharge
(ESD). When handling, care must be taken so that the
devices are not damaged. Damage due to inappropriate
handling is not covered by the warranty.
The following precautions must be taken:
• Do not open the protective conductive packaging until
you have read the following, and are at an approved
anti-static work station.
• Use a conductive wrist strap attached to a good earth
ground.
• Always discharge yourself by touching a grounded bare
metal surface or approved anti-static mat before picking
up an ESD-sensitive electronic component.
• Use an approved anti-static mat to cover your work
surface.
Card Removal and Installation
Once you are properly grounded, follow this sequence of
steps to properly set-up and configure the Symetrix AEC
Coprocessor Module in your Radius NX 4x4 or Radius NX
12x8 hardware.
First, make sure the unit is powered down. Next, you must
remove the two rack ears and the lid. To do this, remove the
6 Phillips head screws from the rack ears and the 3 Phillips
head screws from the rear of the frame. Lift the lid up using
the two tabs in the rear of the lid.
If your Radius NX 4x4 or Radius NX 12x8 unit has an AEC
Coprocessor Module installed, unscrew and remove it
by removing the two stainless steel Phillips head screws
located on the top of the card. Gently pull the card up to
disconnect the two 50-pin connectors. The card is no longer
attached to the frame. Carefully remove the card from the
chassis.
To install a new module, align and feed the connectors on
the AEC Coprocessor Module and align the screw holes
in the card with the standoffs on the motherboard. Look
through this hole and align with the standoff and then,
carefully, apply an even downward pressure until you feel
the card seat into the 50-pin sockets. Use the two stainless
steel screws provided and mount the board to the standoff.
Do not over tighten these screws. The 50-pin connectors on
the Symetrix AEC Coprocessor Module should not be under
any tension when properly installed.
Finally, replace the lid and rack ears.
Step 1:
Step 2:
To watch a video showing
AEC Coprocessor Module
installation, scan QR code.
