Symbol SE 923, Integration Manual

Page: 113 / 238

5-61
Parameter Menus
Set Lengths for Interleaved 2 of 5
Parameter # L1 = 0x16, L2 = 0x17
Lengths for I 2 of 5 may be set for any length, one or two discrete lengths, or lengths within
a specific range. The length of a code refers to the number of characters (i.e., human readable
characters) the code contains, and includes check digits. See
Table B-5 on page B-7 for ASCII
equivalents. To set lengths via serial commands, see Setting Code Lengths Via Serial
Commands on page B-6.
One Discrete Length - This option allows you to decode only those codes containing a
selected length. For example, if you select I 2 of 5 One Discrete Length , then scan 1 , 4 , the
only I 2 of 5 symbols decoded are those containing 14 characters. Numeric bar codes begin
on page 5-102. If you make an error, or wish to change your selection, scan the
CANCEL bar code on page 5-104.
I 2 of 5 - ONE DISCRETE LENGTH
Two Discrete Lengths - This option allows you to decode only those codes containing two
selected lengths. For example, if you select I 2 of 5 Two Discrete Lengths , then scan 0 , 2 , 1 ,
4 , the only I 2 of 5 symbols decoded are those containing 2 or 14 characters. Numeric bar
codes begin on page 5-102. If you make an error, or wish to change your selection, scan
the
CANCEL bar code on page 5-104.
I 2 of 5 - TWO DISCRETE LENGTHS