Symbol P360, Product Reference Manual

Page: 28 / 198

2-8
P460/P360 Memory Scanners Product Reference Guide
Inserting the Battery
1. Place the top portion of the battery (curved side up, contacts toward top) into the
scanner and then slide it up the handle.
2. Replace the battery compartment cover.
3. Slide the release latch up to secure the cover in place.
Connecting to a Host
When Using the Scanner as a Batch Device
When using the scanner as a batch device (uncorded) running off its battery, you can
transmit stored data to a host in one of two ways:
• through a cable connected directly to the scanner
• through a cradle.
When Using the Scanner as a Corded Device
When using the scanner as a corded device, power and host communications take place
using a cable.
RS-232 Communication with a Host
1. Make sure all host devices are powered down.
2. Plug the communication cable’s connector into an appropriate RS-232 (serial) port
on the host device.
3. If using a cradle for communication, plug the power supply lead into the Power port
on the bottom of the cradle.
If using a cable directly connected to the scanner, plug the power supply lead into
the power port on the cable’s connector (see
Figure 2-1 on page 2-2 ).
4. Connect the power supply into an AC receptacle.