Symbol P 370 RF, Reference Manual

Page: 27 / 183

2-5
Set Up
Using A Synapse Cable
1. Make sure all host devices are powered down.
2. Connect the Synapse Adapter cable to COM1 in the cradle (see Figure 2-1 on page
2-4).
3. Connect the Adapter cable to the Synapse Interface cable.
4. The Synapse Adapter cable has a flying power lead. Connect this lead to the
receptacle in the Synapse Interface cable, as shown in Figure 2-3. See the Synapse
guide for details.
Figure 2-3. Synapse and Adapter Cable
5. Connect the Synapse Interface cable to the host.
6. Connect the power connector of the power supply (p/n 59-14000-101) into the
Power port on the cradle (see Figure 2-2).
7. Connect the appropriate line cord to the power supply and into an AC receptacle.
8. The indicator light on the cradle blinks, signifying successful power-up.
9. Scan the appropriate Synapse bar codes to set up the Synapse cable for your
specifications.
10. Rotate the antenna to the vertical position.
Wand Emulation, OCIA, OCR, Keyboard Wedges
See the appropriate Synapse cable instructions. An adapter cable is required.
Synapse Interface
Cable
Adapter Cable
Flying Power Lead
To Host
To Cradle