Symbol MK2200 MicroKiosk, Product Reference Manual

Page: 49 / 278

Installation 2 - 21
Installing/Removing the RF Card
To remove and re-install the RF card:
1.
Disconnect power from the MK2200.
2.
Gently place the MK2200 face down on a flat surface, using care not to damage the touch panel display.
3.
Remove the PCMCIA access cover.
Figure 2-17
MK2200 Rear View
NOTE
T
his section applies to factory-shipped RF models only.
PCMCIA Access Cover
CAUTION When removing an access cover, follow proper ESD precautions to avoid damaging sensitive
components. These precautions include, but are not limited to, working on an ESD mat and ensuring that the
operator is properly grounded. Failure to apply proper ESD precautions can damage the MK2200 and void the
warranty.