Symbol MK2000 MicroKiosk, Product Reference Manual

Page: 98 / 194

6-4
MK2000 MicroKiosk Product Reference Guide
Remapping Buttons
The four buttons can be used individually, or in combinations. 14 of the 15 combinations
can be remapped to a virtual keycode that represents a given character or key sequence,
as defined in the table at the end of this section. The other combination is permanently
mapped to reset. Use the Control Panel - Button Definitions utility to remap the buttons.
Note 1: To disable a button combination, set its mapping to 0.
Note 2: To perform a cold boot press and hold buttons B and C until the display goes blank
(typically 15 seconds) then release buttons, see Figure 1-1 on page 1-3. The MK2000
reboots.
Table 6-2. Remapping Buttons
Button Combo Mapping (Default or Permanent) Hex Code
A Up (D) 0x26
B Down (D) 0x28
C Left (D) 0x25
D Right (D) 0x27
AB Enter/Return (D) 0x0D
AC Alt-Down (pop-up combo box list) (D) 0xC3
AD Alt (D) 0x12
ABC (see Note 2 below)
ABD Shift-Tab (move to previous control) (D) 0xC2
ACD Calibration (D) 0xC4
BC Reset (P) (see Note 2 below)
BCD (see Note 2 below)
BD Tab (D) 0x09
CD Cancel/Escape (D) 0x1B
ABCD (see Note 3 below)