Symbol MiniScan MS XX07 Series, Integration Manual

Page: 221 / 406

10-113
Parameter Menus
Event Reporting
The host can request the decoder to provide certain information (events) relative to the
decoder’s behavior. Enable or disable the events listed in
Table 10-3 by scanning the
appropriate bar codes on the following pages. Parameter number format for these
parameters follows those shown in the
Simple Serial Interface (SSI) Programmer’s Guide
for parameters numbered 256 or higher.
Table 10-3. Event Codes
Event Class Event Code Reported
Decode Event Non-parameter decode 01h
Boot Up Event System power-up 03h
Parameter Event Parameter entry error
Parameter stored
Defaults set (and parameter event is enabled by default)
Number expected 07h
08h
0Ah
0Fh