Symbol LS3478-ER, Reference Manual

Page: 151 / 371

Symbol LS3478 Product Reference Guide 9-8
Ignore Unknown Characters
Unknown characters are characters the host does not recognize. When Send Bar Codes With Unknown Characters is selected,
all bar code data is sent except for unknown characters, and no error beeps sound on the scanner. When Do Not Send Bar Codes
With Unknown Characters is selected, bar codes containing at least one unknown character are not sent to the host, and an error
beep sounds on the scanner.
*
Send Bar Codes With Unknown Characters
(Enable)
Do Not Send Bar Codes With Unknown Characters
(Disable)
Convert All to Code 39
By default, the wand emulation interface sends data to the attached host in the same symbology that was decoded. This can present
a problem for older systems that do not recognize some newer symbologies (for example, GS1 DataBar).
Enabling this parameter ignores the symbology that was decoded, and transmits the data as if it were a Code 39 bar code. Any
lowercase characters in the original data stream transmit as uppercase characters. This also allows ADF formatting.
If Ignore Unknown Characters is enabled, characters that do not have a corresponding character in the Code 39 symbology set are
replaced by a space.
If Ignore Unknown Characters is disabled, if characters that do not have a corresponding character are encountered, the scanner
emits an error beep and does not transmit data.
ADF Note: By default, the wand emulation interface does not allow scanned data to use ADF rules. Enabling this parameter allows
the scanned data to use ADF rules. See
Chapter 14, Advanced Data Formatting .
Convert All to Code 39 for Wand Host
(Enable)
*
Do Not Convert All to Code 39 for Wand Host
(Disable)