Symbol LS 3408, Product Reference Manual

Page: 96 / 432

LS 3408 Product Reference Guide 6-6
RS-232 Host Parameters
Various RS-232 host types are set up with their own parameter default settings. Selecting the host
type sets the parameter defaults as listed in
Table 6-2 .
Table 6-2. Terminal Specific RS-232
Parameter
Standard
RS-232
(Default) ICL
Wincor-
Nixdorf
Mode A
Wincor-
Nixdorf
Mode B Olivetti Omron
OPOS/
JPOS Fujitsu
Transmit
Code ID No Yes Yes Yes Yes Yes Yes Yes
Data
Transmission
Format Data as is Data/
Suffix Data/Suffix Data/Suffix Prefix/Data/
Suffix Data/Suffix Data/Suffix Data/
Suffix
Suffix
CR/LF
(7013) CR (1013) CR (1013) CR (1013) ETX (1002) CR (1013) CR (1013) CR (1013)
Baud Rate 9600 9600 9600 9600 9600 9600 9600 9600
Parity None Even Odd Odd Even None Odd None
Hardware
Handshaking None RTS/CTS
Option 3 RTS/CTS
Option 3 RTS/CTS
Option 3 None None RTS/CTS
Option 3 None
Software
Handshaking None None None None Ack/Nak None None None
Serial
Response
Time-out 2 Sec. 9.9 Sec. 30.0 Sec. 30.0 Sec. 9.9 Sec. 9.9 Sec. 30.0 Sec. 2 Sec.
Stop Bit
Select One One One One One One One One
ASCII Format 8-Bit 8-Bit 8-Bit 8-Bit 7-Bit 8-Bit 8-Bit 8-Bit
Beep On
<BEL> Disable Disable Disable Disable Disable Disable Disable Disable
RTS Line
State Low High Low Low = No
data to send Low High Low = No
data to send Low
Prefix None None None None STX (1003) None None None
*In the Nixdorf Mode B or OPOS/JPOS, if CTS is Low, scanning is disabled. When CTS is High, the user can scan bar codes.
**If Nixdorf Mode B or OPOS/JPOS is scanned without the scanner connected to the proper host, it may appear unable to scan.
If this happens, scan a different RS-232 host type within 5 seconds of cycling power to the scanner.