symbios logic J21971S-0398, Installation Manual

Page: 34 / 86

Installing the Rackmount Command Module
Connect the Interface Cables
24 MetaStor Command Module Installation Guide Revision A, March 1998
b If the command module is in the middle of the SCSI
bus
, attach the outgoing SCSI cables to controller A, J5
(Host A OUT) and controller B, J6 (Host B OUT). Attach
the other end to the next SCSI device. If the command
module is at the end of the SCSI bus, install terminators
on connectors J5 and J6.
c Go to Step 8 .
8 Connect the drive SCSI cables.
●
For the deskside command module, refer to the cabling
examples in
“Deskside SCSI Cabling Examples” on page 26 .
●
For the rackmount command module, refer to the cabling
examples in
“Rackmount SCSI Cabling Examples” on page
29.
The cabling examples show ways to connect one or more command
modules to one or more MetaStor Drive Modules. Review the
illustrations and determine which example most closely matches the
configuration at your installation site. Then, attach SCSI cables to the
drive SCSI connectors on the command module and to the SCSI
connectors on the drive modules as shown in the appropriate example.
Figure 11 Interface Connections on Command Module
6* .) 7&0
65 .) +$(0
68% 69% 6:%
6-;% 6--
64 .) 7&0
6< .) +$(0
6* .) 7&0
65 .) +$(0
64 .) 7&0
6< .) +$(0
!
68% 69% 6:%
6-;% 6--
!