SG
-
S200, SG
-
S400, SG
-
S500
5
ProxySG
Quick Start Guide
Rack Warnings and Precautions
CAUTION!
Before mounting the appliance:
Power off the appliance and disconnect all cables.
Verify that the weight of the system does not exceed the
rack’s fully populated weight limit. For more information,
refer to the manufacturer’s instructions included with
the rack.
For weight stability, load the rack from the bottom up.
Read the “Rack Mount Warnings” section of the
Safety
and Compliance Guide
.
Take adequate safety and grounding measures to avoid
creating an electrical shock hazard and to prevent
bodily injury.
The appliance is heavy. A two-person lift or mechanical
aid is recommended to lift the appliance from the carton
and install it in the rack.
Do not place objects on the appliance or use it as a
work surface. Its mounting hardware does not support
additional weight.
Install the Appliance into the Rack
To install the appliance into a 4-post equipment rack:
1. Disassemble the two slide-rail assemblies. Extend the
inner rails while pressing the center release tabs, then
fully remove them (
a
).
2. Attach the two inner rails to the chassis sides, aligning
the rails with the mounting posts on the chassis, then
slide the rails forward (
SG
-
S200
,
SG
-
S400
) or rearward
(
SG
-
S500
) until they snap into place. Secure each rail
with one (
SG
-
S200
,
SG
-
S400
) or two (
SG
-
S500
) M4x4L
screws (
b
).
3. For
SG
-
S200
and
SG
-
S400
appliances, attach the two
rack ears to the chassis, aligning them with the raised
screw holes and orienting them with the captive screw
heads toward the front of the appliance. Secure each
rack ear with two M3L4 screws.
4. Install the two outer rails into the 4-post equipment rack (
c
):
Secure the rear brackets to the front brackets with six
M4x4L (
SG
-
S200
,
SG
-
S400
) or
M4x5L
(
SG
-
S500
)
screws, three per side, placed equidistantly. Do not yet
fully tighten the side-mounting screws.
Figure 2: SG
-
S500 Slide-Rail Installation
