4. FUEL INJECTION SYSTEM
4-22
DTC
Code
Solution
Priority
Flash
code
Message Solution
Operation
P0505 2 9
Application
range abnormal
of the air
by-pass valve
1. Check if the openness of idle speed by-pass valve
is within specification. (40~100%)
2. Make sure if the idle speed valve openness is in
normal. (stuck or poor adjustment of air screw)
3. Make sure if the intake manifold is leaking.
P0251 2
10
Abnormal fuel
injector
1. Make sure if the fuel injector resistor is within
specification. (14.5
Ω
, 20
℃
)
2. Make sure if the connector or wire is in open-circuit.
(the 3
rd
terminal of ECU)
3. Make sure if the fuel injector power supplied is in
normal. (12~15V)
P0350 2 11
Abnormal
ignition circuit
1. Make sure if the ignition coil resistor is within
specification. (0.63
Ω
, 23
℃
)
2. Make sure if the connector or wire is in open-circuit.
(the 12th terminal of ECU)
3. Make sure if the ignition coil power supplied is in
normal. (12~15V)
4. Make sure if the ignition coil is normal according to
the new component replacement procedure.
P0230 2 12
Abnormal fuel
pump relay
1. Make sure if the connector or wire is in open-circuit.
2. Replace with new relay to make sure if this
abnormal is disappeared.
P0219 2 13
Engine
over-speeding
1. Engine speed exceed safety limit. Decreasing the
speed and then the DTC code disappeared.
2. Check if the CVT belt is broken.
P1560 2 14
Abnormal 5V
driving voltage
1. Make sure if the 18
th
terminal of ECU is 5V.
2. Make sure if the sensor’s power voltage is 5V. (The
16
th
& 18
th
terminals)
3. Replace the ECU and confirm again.
P0700 2 15
High RPM
warning for
starting engine
1. If the engine speed is exceed 300rpm as starting, in
order to prevent run-away, the ECU will decrease
engine speed or stop the engine.
2. Rider should avoid to starting engine with WOT
suddenly.
3. Check if acceleration cable is stuck. Re-set the idle
speed adjustment position.
P0115 2 16
Abnormal
engine
temperature
sensor
1. Make sure if the sensor’s resistor is within
specification. (25
℃
, 10319~11981
Ω
)
2. Make sure if the sensor’s wire is in open-circuit. (the
9th terminal of ECU)
3. Make sure if the sensor is normal according to the
new component replacement procedure.
P1561 2 17
Abnormal
engine
temperature
gauge
P0650 3 18
Abnormal
warning lamp
1. Check if the warning lamp is burnt.
2. Check if the warning lamp circuit is open. (the 4
th
terminal of ECU)
P1410 2 19
Adjustment of
CO
P0105 2 20
Abnormal MAP
sensor
1. Make sure if the sensor’s voltage is within
specification. (101kpa, 3.925V)
2. Check if the sensor circuit is open. (the 8
th
terminal
of ECU)
3. Make sure if the sensor is normal according to the
new component replacement procedure.
