Competitor Product Comparison
Confidential
– for internal use only
Gray/White
Gray/White
Purple/Black
CONNECTING EMERGENCY BATTERY BACKUP AND INSTALLING TEST BUTTON:
Connecting the Emergency Battery Backup (See Fig. 5):
1. Remove top facing cover plate and pull all wires out from inside and out of the flexible metal conduit coming from the Emergency Battey unit (EM).
2.
Connect the incoming switched power to the driver’s black wire.
3. Connect the ground wires (green).
4.
Using the wires coming from the EM unit’s flexible conduit, connect the un-switched power to the EM pack’s black wire and white to white (common).
5.
Also using the wires coming from the EM unit’s flexible conduit, connect the incoming Test Switch wires brown to brown and pu rple to purple.
6. For dimming wire connections, connect the incoming dimmer wires purple (+) to purple (+) and gray (-) to gray (-).
7. Replace the top cover plate.
Emergency battery backup is now installed.
If installed correctly battery backup button will glow red and once the button is pressed luminaire will dim to emergency level. Once the button is
released the luminaire will turn off momentarily before returning to original output.
Figure 5
Driver Hot
(Black)
Driver Ground
(Green)
Switched
Hot
Ground
(Green)
Driver (+)
Purple/Black
Purple/Black
0-10V
Dimmer Wiring
Driver (-)
Gray/White
Gray/White
Coming Out of
EM’s Flexible Metal
Conduit
EM Pack A
(Black)
EM Pack A
(White)
EM pack
(Brow n)
EM pack
(Purpl e )
Un-swi tch ed
Hot
(Black)
Common
(White)
Test Switch
(Brown)
Test Switch
(Purple)
ADDING A WALL DIMMER
This f ixture is compatible with 0-10V output dimming controls. Using the 0-10V dimming the light output will range f rom 10% - 100%. To get to 0% light output (OFF) it
is necessary to disconnect the input power from the LED drivers. This can easily be done by inserting a relay/switch between the line and load connectors inside the
f ixture. Connect dimmer or wall switch to dimming inputs on driver. (See Wiring Diagram 2 and 3)
CLEANING AND M AINTENANCE
• To maintain the fixture efficacy occasional cleaning of the outer lens surface may be needed.
• Use a mild soap or detergent, which is essentially neutral pH (pH approximately 6 to 8), nonabrasive, and
which contains no chlorinated or aromatic hydrocarbons.
• Wash thoroughly, using a soft cloth.
• Rinse with clean, cold water and wipe dry.
TROUBLE SHOOTING CHECKLIST: If luminaire does not work
– Check your power source.
– Check electrical connections.
3959817
