3983099
Figure 16 Figure 17
Mounting with Yoke Mount (NAED 61879):
1. Remove the bracket mounting screws on the fixture.
2. Install the bracket on the fixture using the screws provided and tighten to secure. (Figure 18)
3. Place the bracket on the surface that will support the fixture and secure with bolts and nuts (not provided) (Figure 19)
Note: Mounting hardware is not included, and it is up to the installer to determine the most appropriate hardware for the
desired mounting location. See figure 21 for the mounting pattern.
4. The yoke mounting bracket allows the luminaire to be adjusted up and down. Loosen the screws on both sides of the bracket
and remove the angle locking screws and set aside. Adjust tilt as needed and screw in the angle locking screws on both sides.
Tighten the screws on both sides of the bracket.
5. Make all wiring connections via the supplied wire leads in accordance with NEC and local codes and pull the wires completely
into splice compartment.
Figure 18
Figure 19
Figure 20
Figure 21
OPTIONAL MOTION SENSOR INSTRUCTIONS:
Summary of Contents for ValueLED 61875
Page 8: ...3983099...
