3
==>
3.
activate the back light
– Press any button on the control panel to activate
the blue color back light. The light will automatically turn off if no button is
being pressed again.
4.
work mode
– Under this mode the convector will operate under the pre-set
temperature. Press the MODE button, the convector is now entering the HOLD
mode. Then press the UP or DOWN button to adjust the pre-set temperature.
The adjustable range of pre-set temperature is 5 – 40°C.
Under this mode, the programming mode will not be activated and the
convector is working under the pre-set temperature continuously.
5.
programming mode
– There are 4 programmable setting (P1 to P4). The
convector is working under the preset temperature, time and cycling from P1
to P4 everyday of the week.
A. Press the MODE button to enter the HOLD mode first.
B. Press the MODE button again to enter the programming mode. The
display will show “P1” flashing.
C. Press UP or DOWN button to adjust the pre-set temperature.
D. Press the MODE button again to set the ‘HOUR’ of by pressing the UP and
DOWN button.
E. Press the MODE button again to set the “MINUTE” of time by pressing UP
and DOWN button.
F. Press the MODE button again and repeat the steps in (C) to (E) to set the
temperature and time of P2 to P4.
E.g. P1 – Temperature 25°C; time 6:00 AM
P2 – Temperature 20°C; time 8:00 AM
P3 – Temperature 25°C; time 6:00 PM
P4 – Temperature 18°C; time 11:00 PM
The convector will work under the above preset time and temperature from P1
to P4 everyday.
Without pressing any button for 15 seconds, the controls will automatically
save the setting.
==>
6.
override mode
–
This mode allows you to temporary CHANGE the preset
temperature in WORK MODE or PROGRAMMING MODE.
Press MODE + DOWN button, the display will flash. Press UP or DOWN button
to set the override temperature.
Press MODE + DOWN button or MODE again to enter the override
temperature. The convector is now working under the OVERRIDE temperature.
If the OVERRIDE temperature is set under the PROGRAMMING MODE, the
convector will only work at that OVERRIDE temperature under the current
program (e.g. P1). When the program automatically proceed to the next
program (P1 >> P2) the OVERRIDE MODE will be cancel and return to the
preset temperature of current program (e.g. P2).
If you want to cancel OVERRIDE mode, press MODE + DOWN button and the
convector will return to WORK MODE or PROGRAMMING MODE.
7.
Query of continuous heating time
– Press MODE button for 5 seconds, the
display will show the total heating time for the previous day.
Press MODE button again for 5 seconds, the display will show the total heating
time of the week.