5
1500W:
Press this button for high heat level. The unit will beep, the pilot light and
indicator light will be on. The fireplace heater will give high heat level. Pressing once
again will stop the high heat level function.
HEAT TEMPERATURE CONTROL KNOB:
To adjust the temperature to your individual
requirements, turn the temperature control dial to the right (clockwise) to increase the
desired temperature and to the left (counter clockwise) to lower the temperature.
May not be exactly as shown.
OPERATION BY THE REMOTE CONTROL
Plug in your electric fireplace and it will beep once, this means you have power and
your remote is ready to operate your electric fireplace.
ON/OFF:
Press this button for main power function. The unit will beep and the indica-
tor light will be on. Pressing again will stop the main power function.
Once the heater is switched off, the indicator light will flash and the unit will keep
working with air flow for 5 more seconds.
FLAME/LOG:
Press this button once for flame effect. The unit will be beep and the
indicator light will be ON. The bulbs for flame effect & log-set will be ON. To adjust the
flame intensity, hold down the button - the flame optics will go higher or lower. Once
you have found the desired setting, release the button. Pressing the button again will
stop the light function.
750W:
Press this button for low heat level. The unit will beep, the pilot light and indi-
cator light will be on. The fireplace heater will give low heat level. Pressing once again
will stop the low heat level function.
1500W:
Press this button for high heat level. The unit will beep, the pilot light and
indicator light will be on. The fireplace heater will give high heat level. Pressing once
again will stop the high heat level function.
REMOTE CONTROL BATTERY REPLACEMENT
Replace with 2 AAA batteries.
WarNiNG:
Do not mix old and new batteries Do not mix alkaline, standard (Carbon-Zinc), or
rechargeable (Nickel Cadmium) batteries.
MAINTENANCE
maiNtENaNcE WarNiNG:
Disconnect power and unplug the power cord before attempting any maintenance or
cleaning to reduce the risk of fire, electric shock or damage to persons. The bulbs in
your unit can become extremely hot. Allow at least 10 minutes between turning off the
unit and removing the light bulbs to avoid the accidental burning of the skin.
riSK OF FirE: DO NOt ExcEED tHE rEcOmmENDED BUlB WattaGE.
REPLACING THE FLAME EFFECT LIGHT
AND LOG-SET LIGHT BULBS
Step 1: Remove 14 screws on the back of fireplace and open the rear cover.
There are 2 larger screws and 12 smaller screws
Step 2: You will find 1 X 40W Type B-10 bulb under log-set bed.
Step 3: Loosen and remove the burnt out bulb and replace with new bulb.
Step 4: Close the rear cover. Secure the larger screws into the top left corner hole
and bottom right corner holes as shown in the diagram. Secure the 12 smaller
screws into the remaining holes. Make sure the screws are in the correct holes
and have been tightened.
Step 5: Plug in the unit.