2
ASSEMBLY INSTRUCTIONS
parts list:
Z. WALL ANCHOR SAFETY CABLE
Wall anchor ................................................................................................................... 1
Screw for wall anchor ................................................................................................. 1
Screw for mantel ......................................................................................................... 1
Safety cable .................................................................................................................. 1
TOOL REQUIRED: PHILLIPS HEAD SCREWDRIVER
WALL ANCHOR SAFETY CABLE
The use of the wall anchor safety cable is highly recommended in order to reduce the
risk of the fireplace being tipped over accidentally.
WARNING:
This cable may reduce possible risk of injury if the fireplace is improperly
handled, but is not a substitute for proper adult supervision. Children should not be
left unattended near any heater.
1. Drill a 5/16” (8 mm) hole in the wall. Insert the plastic wall anchor into the hole
and gently tap until the flange on the anchor is against the wall surface.
2. Position the back edge of the mantel close to the wall.
3. Attach the safety cable to the mantel using the screw for the mantel. See fig. A.
4. Use the screw for wall to attach the other end of safety cable to the wall.
5. Make sure all screws are tight.
Fig. A
OPERATION
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach,
you may use an extension cord rated for a minimum of 1875 WATTS. Once the
fireplace insert has been properly connected to a grounded electrical outlet, it is
ready to operate.
The controls are located behind the grill below the front glass and can be accessed by
pulling the grill from the top, forward and down.
O/I:
Press this button for main power and flame effect. The indicator light will turn
on. See below for other control instructions.
750W:
For low heat function – Press this switch while O/I switch is in the on position.
The indicator light will turn on.
1500W:
For high heat function – Press this switch while O/I switch and 750W switch
are in the on position for high heat. The indicator light will turn on.
Temperature Control:
To adjust the temperature to your individual requirements,
turn the temperature control dial to the right (clockwise) to increase the desired
temperature and to the left for lower temperature. This temperature control dial
can only be used while the O/I switch and 750W & 1500W switches are in the ON
position.
When the heater reaches the desired temperature, the heater and 750W/1500W
indicator light will turn off but the fan still keeps working with air flow. Adjust this
knob to restart heater.
Dimmer Control Knob:
Turn the dimmer dial clockwise or counter clockwise to get
the desires flame intensity. The dimmer switch can only be used when the O/I switch
is in the on position.
Note:
When the O/I switch is turned off, all other heater functions will stop even
though the switches may be in the on position.
Note:
In order to shut down the heater safely, it is recommended to turn the
temperature control knob to lowest setting and allow the heater to cool down before
pressing the O/I switch to off position.
