Sylvania SOM995P-26FDC Instruction Manual Download Page 7

7

Fig. F

Fig. G

3. Attach the small L-bracket and lock in place with screws as shown in Fig. G.

CLEANING

To clean unit first turn off controls on unit and unplug the unit from power source.  
To clean glass display panel; remove dust with clean dry cloth or remove finger  
prints and other marks clean glass with clean damp cloth. Do not use abrasive 
cleaners or spray liquids on glass display panel surface. Metal and metal painted 
parts should be cleaned with damp cloth. Do not use abrasive cleaners or spray 
liquids on these surfaces. 

WARRANTY

Every electric fireplace heater is tested before it leaves the factory and it is 
guaranteed for one year. If the unit should fail to operate correctly within one year 
from the date of purchase, call customer service at 1-800-459-4409 (EST). We will, at 
our discretion either repair or replace the unit. It will have to be returned to us freight 
prepaid and we will return the repaired or replaced unit to you freight prepaid. The 
company’s sole obligation is to repair or replace the unit. 

This warranty is void if in the opinion of Quality Craft the unit has been tampered 
with, altered, misused, damaged, abused or used with the wrong power source.  
Light bulbs and remote batteries are not covered by this warranty. The warranty is  
for homeowner use only and does not cover units used in commercial situations.

Imported by  

Quality Craft

 

Laval, Quebec, Canada H7S 2G7 
1-800-459-4409 (EST) 
www.qualitycraft.com    

Made in China

Summary of Contents for SOM995P-26FDC








Reviews: