21
EN
1A23
Connections
1
Use a standard antenna cable to connect the wall jack to the ANT. IN jack on STB.
2
Use a standard audio cable to connect the audio output jacks (L, R) of STB to the audio input jacks (L, R) on
the TV.
NOTE:
If your TV is monaural (MONO) and has only one audio jack, connect a standard audio cable (white) from
the audio output jack (white) on STB to an audio input jack (white) on the TV. The red cable and jack will
not be used.
3
Use a standard video cable to connect the video output jack on STB to a video input jack on the TV.
4
Set the resolution selection switch to “480i.”
5
After completing the connection to the TV, plug the AC power cord of the TV into the AC outlet, then turn
the TV on.
6
Set the TV to the input mode.
NOTE:
Refer to the TV owner’s manual for further information.
7
Plug the AC power cord of STB into the AC outlet, then turn STB on.
NOTE:
When using a standard video cable to connect, the resolution of the video signal output will always be 480i.
Rear panel of STB
Audio cable
Video cable
To audio input jacks (L, R)
To a video input jacks
NOTE:
Audio cable and video cable are not included.
STB connection using VIDEO output to SDTV
2 Connections
ST201UB.qxd 04.3.9 4:04 PM Page 21
