SY-HDBT-70S EXTENDERS
3
www.sy.co.uk
Rear
Name
Transmitter
Receiver
IR IN
Input from IR detector (3.5mm stereo Jack)
IR OUT
Output to IR emitter (3.5mm Jack)
HDMI
HDMI input from HDMI source
HDMI output to HDMI display
SIGNAL LED
LED to indicate that the HDMI signal is present at the HDMI connector
Using the HDBT HDMI Extenders
HDMI Extender
Connect a HDMI source to the HDMI IN socket on the HDBT-70ST and connect a HDMI
display to the HDMI OUT socket on the HDBT-70SR. Connect a Cat6 UTP cable to the HDBT
sockets of both the transmitter and receiver units. Connect the 48V Power supply to either
the Transmitter or the Receiver unit.
Status LEDs
The LINK LED indicates the link status of the transmitter and receiver units, solid ON for a
successful link and off when a link cannot be established.
The green STATUS LED indicates that the HDBaseT signal is being transferred between the
transmitter and the receiver.
The SIGNAL LED on the transmitter indicates that HDMI data is being received from the
HDMI source. For the receiver it indicates that HDMI data is being sent to the HDMI display
device. The SIGNAL LED will remain OFF for any of the following conditions:
1.
The HDMI source is not outputting data, the HDMI cable is either not connected
or it is faulty.
2.
The HDMI display is not connected or powered up, or the HDMI cable is faulty.
3.
The HDMI display is not set to use its HDMI input.
