SWS Warning Systems Inc. – 7695 Blackburn Pkwy., Niagara Falls, ON, Canada
Tel: 1-877-357-0222 | Fax: 1-905-357-9122 | Email: [email protected]
300133_RevD
2
|
P a g e
93210/93310/93400 Lights
If you have purchased a linear floodlight, proceed to page 3 for instructions.
The light is shipped with a blue protective cover on the front shield. This should be removed
after
installation to ensure proper operation of the light.
Mounting
Pedestal Mount
The work-light comes with the mounting bracket pre-assembled and
attached.
1. Prepare the mounting surface by predrilling a
11
/
32
” –
3
/
8
” hole where
the light will mount to the vehicle.
2. Remove the nut and spring lock washer from the carriage bolt.
3. Pass the bolt through the mounting surface.
4. Place the spring lock washer on the bolt and secure in place with the
nut.
5. Adjust the desired horizontal position of the light, and tighten in place.
6. Adjust the vertical position of the light and tighten the two cap screws
on the side of the light to secure in place.
Wiring
The light is supplied with two different wired connectors, a connector to wire lead and connector with
inline fuse, switch and battery leads.
You may want to mount the light first to ensure the wires reach the lights.
In the event the wire lengths are not of adequate length, you may extend them using no less than
18AWG wire. Lengths should be kept to a minimum.
Connecting two lights to the same switch can be completed.
Use good quality materials and proper wiring technique when attempting this.
1. Ensure the switch is in the OFF position (the red LED side of the switch is away from the switch body).
2. Connect the battery leads to the electrical system.
3. Run the wire and the switch to the switch mounting position, and install the switch.
4. Connect the pigtail from the light to the switch harness connector.
