5.3.3 Torch cuts but the cutting quality is poor.
5.3.3.1 Current (A) control set too low. Increase current setting.
5.3.3.2 Torch moves too fast across the workpiece. Reduce cutting speed.
5.3.3.3 Excessive oil or moisture in torch. Hold torch (3 mm) from clean
surface while purging and observe oil or moisture build-up (do not
activate torch). If there are contaminants in the gas, additional
filtering may be needed.
5.3.3.4 Lack of air pressure. Check the air pressure and air flow and adjust
to the appropriate position.
STEALTH DIGI-CUT 100 CNC
16
