− Telephone Answering Machine −
274
17.10.5
Remote activation of the answering machine
The remote access feature enables the answering machine to be
switched on via any telephone which uses the tone dialling method.
Dial your own phone number
Button *,
Wait 10 rings, press after the
acoustic signal and enter the PIN
code
Note:
If an incorrect entry is made, the outgoing message is
repeated. If the security code is entered incorrectly three times,
the line is automatically disconnected.
Button 8
Switch the answering machine on/off
Note:
Other functions can be executed via the remote access
system within the following 8 seconds. Refer to the table in
Chapter 17.10.4.
Replace receiver
End remote access
17.10.6
Free of charge pre−remote access
The free of charge pre−remote access function can be used to determine
whether messages have been left on your answering machine without
accruing any telephone charges.
To do this, set the Delay taking calls" function to toll−saver". Refer to
Chapter 17.5.3.
When you subsequently call the answering machine while underway, the
answering machine responds as follows:
S
If your call is taken after 2 rings, there are new messages on
the answering machine.
S
If no new messages have been recorded, the call is not taken
after 2 rings. Replace the receiver immediately because the
call will be taken after 4 rings. No telephone charges are
necessary because no connection has been made.
Summary of Contents for CD738
Page 279: ...279...
