4. OLED Display
Boot Screen
Main Screen
（
When Tx and Rx both have no signal connection, (When Tx and Rx have normal signal connection,
Tx and Rx display the same. Fig.1) Tx and Rx display the same. Fig.2)
Note: Channel switch is adjusted up and down by the red five-direction adjustment button under OLED, 11
wireless channels in total.
Switch Screen
a: ( Tx switch screen is adjusted left and right by the red five-direction adjustment button under OLED, same
screen display. Fig 3)
b: ( Rx switch screen is adjusted left and right by the red five-direction adjustment button under OLED, same
screen display. Fig 4)
Remark:
1. Instant playback mode is off by default.
2. Turn on instant playback mode "ON" or reset "YES" by adjusting the red five-direction adjustment
button up and down to select the required mode, and then press the red button vertically.
3. Under scan mode, the output signal is interrupted, and the output monitor displays "SPECTRUM
ANALYZER". After 10s, the receiver OLED displays the signal strength of all 11 channels as shown
in fig 4, and then select the stronger channel by the red five-direction adjustment button on the
transmitter.
4. Support manual selection of the best channel only through the transmitter.
5. Setup connection
⑴
Connect the “SDI in/HDMI in” port of SW-M450 transmitter with the SDI/ HDMI out video source.
⑵
Connect the “SDI OUT” port of SW-M450 receiver with the SDI/HDMI in of monitor or other receiving
devices.
⑶
Power the SW-M450 transmitter and receiver, the transmitter “Power” LED on, “Video” and “Link” LED flash,
wait for 5s and OLED on; the receiver wait for 5s, OLED on; they will automatically search the network, and
detect video signal. When the “Video” and “Link” LED of transmitter is constant on, the OLED infomation of
transmitter and receiver are the same, and the output display is normal.
Remark: 1. When SW-M450 transmitter and receiver are powered on, the power switch shall be set to “ON”.
2. SW-M450 transmitter supports SDI input and HDMI input, and it will automatically detect the
connected signal input. If both SDI and HDMI are connected, it will give priority to transmit SDI signal.
