4. Setup connection
⑴
Connect the SDI video source with the “SDI IN” port CW-S150 transmitter.
⑵
Connect the “SDI OUT” port of CW-S150 receiver with monitor or other receiving devices.
⑶
Power the CW-S150 transmitter and receiver, the transmitter “Power” LED on, “Video” and “Network” LED
flash; the receiver “Video” and “Network” LED flash; they will automatically search the network, and detect
video signal, when the “Video” and “Network” LED is constant on, the output display is normal.
5. Pairing
⑴
Connect the SDI video source with the “SDI IN” port CW-S150 transmitter.
⑵
Connect the “SDI OUT” port of CW-S150 receiver with monitor or other receiving devices.
⑶
Power the CW-S150 transmitter and receiver, the transmitter “Power” LED on, “Video” and “Network” LED
flash; the receiver “Video” and “Network” LED flash; the monitor or switcher will display as Fig. 1
⑷
Press the Receiver Pair button and hold for 5-10 seconds, the monitor or switcher will display Fig.2, then
release the Pair button; Press the Transmitter Pair button and hold till the monitor or switcher display progress
bar as in Fig. 3, then release the Pair button.
⑸
When the progress bar completed, they are successfully paired.
Note: 1. Please keep the transmitter and receiver in distance of 1-2m to avoid pairing failure.
2. Please do not use more than 3 sets of devices under the same environment to avoid interference.
3. User can use at most 4 receivers to pair with one transmitter under the same environment.
6. How to get the best effective of Wireless Transmission
Set the antenna on both transmitter and receiver vertically straight up, no request to spread. If lay down
⑴
installation, still keep the antenna vertically straight up to extend transmission distance and stabilize
transmission quality. (See Fig. 4)
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Summary of Contents for CW-S150
Page 11: ......