Safety Information
Consider the following notes mandatory when you set up, connect and use the
XSP / XSR.
This product is approved for professional use only, it is not intended for
household usage. Follow the safety instructions closely, when setting up,
connecting and using the device. Read the manual before operating the device
and pay attention to all the instructions or warnings given in this manual or
printed on the product.
Use this device only in accordance with local laws and regulations.
Safety Precautions
Disconnect the device from the AC power supply before removing any cover
or part, including fuse, even when not in use.
Ensure the device is electrically connected to ground (earth).
Use only a source of AC power supply that complies with local building and
electrical regulations and which has both overload and ground-fault (earth
fault) protection.
Connect the device to a AC power supply using the supplied power cable.
Before using the device, check that the power distribution equipment and
cables are in perfect condition and rated for the current required of all
connected devices.
Isolate the device from power supply immediately if the power cable or
power plug are in any way damaged, defective or wet, or if they show signs
of overheating.
Do not expose the device to rain or moisture.
Do not operate the device if any cover or component is missing, damaged or
deformed.
Refer any service operation not described is this manual to SWISSON AG.
Provide unrestricted airflow around the device.
Do not operate the device where the ambient temperature exceed 55 C
(131
F)
Do not modify the device in any way other than described in this manual or
install other than genuine SWISSON parts.
Do not attempt to bypass the fuse. Replace defective fuse with one of the
specified type and rating only.
When suspending the device, ensure that the supporting structure and all
hardware used is capable to withstand at least 10 times the weight of all
devices suspended together.
Install as described in this manual, a secondary attachment such as a safety
cable that has been approved by an official body such as, e.g. TÜV (German
Technical Monitoring Association) as a safety attachment for the total weight
it secures. The safety cable must comply with EN 60598-2-17 Section 17.6.6
and be capable of bearing a static suspended load representing 10 times the
actual weight of the device.
Make sure that all external covers and rigging hardware are securely
fastened.
Provide clearance underneath the work area and a stable platform whenever
installing, servicing or moving an overhead device.
Do not use the device in areas where it is exposed to direct sunlight.
Do not use the device in areas that are considered to be 'highly inflammable'.
3
E
