14
Repeat the above steps for the remaining characters. Then, press [Cancel] to finish inserting characters.
Press [Cancel] again to quit the editor.
Press [OK] to store the changes or press [Cancel] to discard all changes.
Removing a Group
Remove a group by choosing
“> Delete”
with the encoder wheel in the group configuration menu (see Adding, Remov-
ing and Editing Groups on page 12) and pressing the encoder knob.
Device Settings and Information
Screen Saver
Under
Screen Saver
, a selection list is presented to you with the following options:
•
Enable
: Screen saver is enabled.
•
Disable
: Screen saver is disabled.
A bullet point is shown next to the currently active setting. Use the encoder wheel to select the desired setting and
push [OK] to apply the setting.
on page 15 for more details about the behaviour of the screen saver.
Device Information
The following information about the device is available under
Home > Menu > Device Settings > Device Information
.
Model
The device model is reported as
“
XES-2T6
”
.
Boot Software
The full version number of the boot software.
Firmware
The full version number of the firmware.
Hardware
The hardware revision.
Restore Default Settings
The default settings can be restored under
Home > Menu > Restore Default Settings
. In this menu, you will be asked
whether you want to continue restoring all settings. Push [OK] to confirm or [Cancel] to abort.
This function will restore all settings to the defaults:
