6
Safety Information
Consider the following notes absolutely when you set up, connect and use the ISP.
This product is not for household use. Read this manual before operating the device, follow the
safety precautions and observe all warnings in this manual.
Use this device only in accordance with local laws and regulations.
Safety Precautions
•
Disconnect the device from AC power before removing any cover or part, including any
fuse and when not in use.
•
Ensure that the device is electrically connected to ground (earth).
•
Use only a source of AC power that complies with local building and electrical codes and
has both overload and ground-‐fault (earth fault) protection.
•
Before using the device, check that the power distribution equipment and cables are in
perfect condition and rated for the current required of all connected devices.
•
Isolate the device from power immediately if the power cable or the power plug is in any
way damaged, defective or wet, or if they show signs of overheating.
•
Do not expose the device to rain or moisture.
•
Do not operate the device if any cover or component is missing, damaged or deformed.
•
Refer any service operation not described is this manual to Swisson.
•
Provide unrestricted airflow around the device.
•
Do not operate the device if the ambient temperature exceeds 55°C (131°F).
•
Do not modify the device in any way not described in this manual or install other than
genuine Swisson parts.
•
Do not attempt to bypass any fuse. Replace any defective fuse with one of the specified
type and rating only.
•
When suspending the device, ensure that the supporting structure and all hardware used
can hold at least 10 times the weight of all devices suspended from them.
•
When suspending the device, install a secondary attachment such as a safety cable that is
approved by an official body such as TÜV as a safety attachment for the total weight it
secures. The safety cable must comply with EN 60598-‐2-‐17 Section 17.6.6 and be capable
of bearing a static suspended load 10 times the weight of the device.
•
Make sure that any external cover and rigging hardware is securely fastened.
•
Block access below the work area whenever installing, servicing or moving an overhead
device.
•
Do not use the device in areas where it is exposed to direct sunlight.
