5. Fasten the hitch mount arms to the outside of the
angle brackets at the front of the tine shield. Use
two M8x20 hex bolts and M8 hex lock nuts.
Tighten and then loosen the nuts slightly.
See figure 3.
6. Fasten the hitch mount arms to the outside of the
hitch arm mount brackets at the rear of the tine
shield. Use two M8x25 carriage bolts, M8 lock
washers and M8 hex nuts. Do not tighten yet.
See figure 3
HITCH MOUNT ARMS
FIGURE 4
10. Tighten the bolts and nuts assembled in step 8.
Tighten the bolts and nuts assembled in step 7.
Tighten the bolts and nuts assembled in step 3.
Tighten the bolts and nuts assembled in step 4.
Tighten and then loosen slightly the bolts and
nuts assembled in step 5.
Tighten the bolts and nuts assembled in step 6.
FIGURE 3
7
. Assemble the front ends of the hitch mount arms
together using two M8x30 hex bolts and M8 hex
lock nuts. Do not tighten yet. See figure 4.
8. Assemble the hitch brackets to the top and bottom
of the hitch mount arms using two M8x50 hex bolts
and M8 hex lock nuts. Do not tighten yet. See
figure 4.
9.Assemble the
Ф
10 hitch pin through the hitch
brackets and secure it with a
Ф
3 hair cotter pin.
See figure 4.
11. Assemble the axle bracket on the outside of the
angle brackets using two M8x20 hex bolts and M8
hex lock nuts. The ends of the axle bracket must
point as shown in figure 5. Tighten and then
loosen the bolts and nuts slightly.
FIGURE 5
12. Assemble the wheels to the axle bracket using two
shoulder bolts and two M10 hex lock nuts. Tighten.
See figure 6.
FIGURE 6
13. Fasten ten spring tines to the square holes in the
bottom of the tine shield. Use a M8x30 carriage
bolt, Ф8 flat washer M8 lock washer and M8 hex
nut for each spring tine. Tighten. See figure 7.
NOTE: Spring tines must seat between dimples.
FIGURE 7
5
