6
Tunnel Twister Assembly Instructions
Entrance Section - 14 bolts
flanged lip
flat lip
Exit Section - 13 bolts
ϵϬȗ^ĞĐƚŝŽŶͲϭϯďŽůƚƐĞĂĐŚ
loc nut
washer
washer
3/4” bolt
Fig. 1
Fig. 1a
A. ENTRANCE SECTION, 90° SECTION AND
EXIT SECTION
NOTES:
• At least two individuals are needed to assemble the
dƵŶŶĞůdǁŝƐƚĞƌ^ůŝĚĞ͘
ͻ dŽĂŝĚŝŶĂůŝŐŶŝŶŐŚŽůĞƐǁŚĞŶĂƐƐĞŵďůŝŶŐƐĞĐƚŝŽŶƐ͕
insert a screwdriver through adjacent holes to
maintain hole alignment.
1.
Identify each slide section as either (1), (2), (3), (4), (5),
or (6) as marked on the lip of each piece.
2.
Assemble entrance section using pieces (1) & (2), one
90° section using pieces (3) & (4), and the exit section
using pieces (3) & (5). Join sections using a 3/4” hex
head bolt, two flat washers, and a loc nut at each
hole junction (FIG. 1), (Fig. 1a), & (Fig. 1b). NOTE:
Fasten each loc nut finger tight until the entire slide
is assembled. Each time you join parts be sure each
flanged lip is mating with a flat lip.
NOTE: Hand tighten the loc nuts only.
Fig. 1b
