Swim & Fun ECO 1093, User Manual

Page: 78 / 128

78
MV--1093-9-2018 . © All rights reserved Swim & Fun Scandinavia ApS
10.2 Wiring diagram
The electrical wiring diagram is
only for general reference.
The swimming pool heat pump
must be connected to the ground
wire, although heat exchanger
unit is electrically isolated from
the rest of the unit. The unit must
still be earthed in order to protect
against short circuits inside the
unit. Bonding is also required.
A power switch should be loca-
ted within sight and be easily
accessible from the heat pump.
This is common practice on
commercial and residential heat
pumps. It allows you to turn off
the power to the unit while it is in
operation.
10.3 Exploded view
No. Part name No. Part name
1 Top cover 23 Right panel
2 Evaporator 24 Temp. knob
3 Pillar 25 Electric plug
4 Electric box cover 26 Electric plug
5 5-position terminal 27 Meter
6 Motherboard 28 Blue rubber ring
7 Clip 29 Water connection cover
8 Clip 30 Switch
9 Fan motor capacitor 31 Red rubber ring
10 Compressor capacitor 32 Water connection cover
11 Electric box 33 Anti-vibration hammer
12 Fan motor bracket 34 High pressure protection sensor
13 Fan motor 35 Return gas pipe
14 Fan blade 36 Exhaust pipe
15 Front panel 37 Suction valve
16 Front grill 38 Low pressure sensor
17 Isolation panel 39 Pipe
18 Service panel 40 Pipe
19 Compressor 41 Distributor pipe
20 Water flow switch 42 Ambient temp. sensor clip
21 Bottom tray 43 Ambient temp. sensor
22 Heat exchanger