MV-1908-11--2017 . © All rights reserved Swim & Fun Scandinavia ApS
39
UK
3.2. RUNNING
1. Check if installation and connections are 100% correct.
2. Check if any metal or foreign objects have been left inside the product.
3. Check all wire terminals are tight.
4. Check there are no bare wires on the terminals touching other terminals.
5. Check the control panel is properly closed.
6. The device must be earthed and attached to an earthed power supply protected by a residu-
alcurrent device (RCD) or residual-current circuit breaker (RCCB) with a nominal residual ope-
rating current of less than 30 mA.
7. Check the power supply frequency is correct for this model.
8. If all connections are correct, run for a short duration without load.
3.3. PROGRAMMING GUIDE
The Clever-Pool has two running modes: Manual mode and Auto mode.
Manual mode is used when you are connecting to a timer. The system time settings are not requi-
red to run in this mode.
Auto mode is used when there is no salt chlorinator or timer and includes up to 4 separate timers
with individual speed options. This is ideal for when you want to run your pool pump at different
times and speeds to take advantage of the lower electrical consumption rates.
In stop and manual mode press the SET/RESET button once to switch to Auto Mode. In stop and
Auto mode press the RUN/STOP button to switch to Manual Mode.
3.3.1 MANUAL MODE
In stop mode the display will now show
MANUAL, LOW RPM and the speed in rpm.
Press the up or down buttons to select the
speed. Alternatively press one of the sy-
stems, pre-set speed buttons LOW, MED,
HIGH.
Press the RUN/STOP button to put it into run
mode, this will start the pump. The CLEVER-
POOL will store the speed and resume at that
speed when switched on again.
To stop the pump simply press the RUN/STOP
button again.
