10
10
8) Take Printhead Unit out of the case.
CAUTION:
Do not touch the circuit boards and Printhead face plate. An ink injection problem
can occur.
F-1-20
F-1-19
9) Put Printhead Unit on the rail guide, and then insert it into Printer
until it stops.
NOTE:
Skewering Shaft must be on Printhead Guide Rails.
CAUTION:
If Printhead is insufficiently inserted, Lower Printhead Release Lever cannot be closed.
To confirm Printhead is in the correct position, see if the end of Printhead grip and the
edge of the inner metal plate are in the same plane as shown in the figure.
F-1-22
F-1-21
