5
2. Training Requirements
The original operating instructions must be accessible to the user before using
the device. The user must be trained on the equipment by the operator /
owner. The operator / owner of the equipment shall bear full responsibility that
proper training is carried out. All original instructions, signs and labels must be
observed when using this device. In addition, use only tested and approved
harnesses, attachment points and connection means. Before commissioning
the device, perform a visual and a functional test.
3. Installation
3.1 Site selection
Before installing the device it is necessary to have carefully examined all factors
that may affect the use of the drum winch and other equipment. These factors
include job set up, environmental factors, location and type of workplace
hazards, location and strength of the anchorage point to which the drum winch
is mounted. Leave yourself enough time to consider all foreseeable
possibilities. Always consult a competent person to who is familiar with the
dangers and localities in the specific workplace
Estimate the expected Load Line length required. Install the unit so that the
Load Line and the Endless Line easily reach the lowest point of the expected
work location. Consider it may need extra length if the person has to perform
work offset from the vertical. The Load Line must not be crossed and but must
always be able to move freely. If necessary include in the work schedule the set
up of safety barriers and signage so that other equipment, materials and people
do not interfere with the proper operation of the unit.
The device including the Load Line and the Endless Line must not pass over
sharp edges or too close to objects where they might catch. Avoid mounting
locations where waste, pollutants, and falling objects may impair or damage the
device, Load Line and Endless Line or cause injury to people.
The drum winch must be free to move at the anchorage point and
must not
be
rigidly mounted. (blue sticker must be outside of the mast and if you use our
SWI-TEC protective-cover the Logo on the cover must be outside of the mast).
The Load Line must
always run vertically
off the drum.
Never install the equipment where the device or lines risk exposure to
electrical hazards.
Note
Create a work plan and a rescue plan before starting the installation. Take into
consideration the original instructions and the risk assessment of the client.
Caution
The person operating the device must be secured against risk of falling with
his/her own tested and approved restraint or fall arrest system. Also, the person
must be safeguarded against falling objects.
