T82
1
9
D
ok
: 101540-
GB 2051
MAINTENANCE - EVERY 10 HOURS OF OPERATION
Check oil level in the tamper leg through the sight glass (1)
The level should be at the middle of the sight glass.
Check and, where necessary, tighten screws and nuts.
Take special care with bolted joints on the rammer foot.
Keep machine clean. The machine shall always be
upright when washed.
Never aim a water jet directly at the cap of the fuel tank.
This is especially important when using a high-pressure
jet. Put a plastic bag over the filler cap of the fuel tank
and secure with a rubber band.
MAINTENANCE - EVERY 100 HOURS OF OPERATION
Change oil (see engine manual).
Replace air cleaner element (see engine manual).
MAINTENANCE - EVERY 500 HOURS OF OPERATION
Change oil in the tamper leg. Screw out the drain plug
and empty the oil into a receptacle.
Save the oil in a can and dispose of it properly.
Refit the plug tight, making sure that the washer seal is
undamaged.
Remove the sight glass and fill with fresh oil as follows.
Refit the sight glass and tighten firmly. The oil level
should be at the middle of the sight glass.
Check the rubber straps on the hood.