© 2015 SWELLPRO All Right s Reserved
39
OSD Convertor
4.6.8.2 Realization
4.6.8.1 Installation
Please follow up below procedures to activate OSD data transmission:
After getting all cables well-connected, below operation is necessary to get the
flight data ready to show on your radio controller:
1. Firstly remove the default cables that connects to the ‘COM’ & ‘M8’ channel in flight controller;
2. Fill the ‘COM’ & ‘M8’ channel with OSD cable according to below Image:
Remark: The cable with 3 colors shall go into ‘COM’ terminal in Flight controller, the 3 pin
Cable with Black wire goes into the ground terminal next to ‘COM’, saying ‘M8’.
3. Insert the other end (4 pins white cable. into the socket of OSD converter that is pasted on the
Receiver.
1. Download the assistant software from link www.swellpro.com , unpack and install it into
computer.
2. Switch on radio controller and power on drone, then Connect Drone with Computer by the USB
cable enclosed (refer to the socket on Power Distribution Board)
RIGHT
OSD Cable
Summary of Contents for Splash Drone Auto
Page 45: ......