6
R2.060219
All rights to changes reserved.
www.swegon.com
2.1.2 Ceiling mounting
The ventilation unit can also be mounted in a ceiling
mounting frame on the ceiling (can be ordered as an
accessory).
Fasten the ceiling mounting frame in ceiling anchor
sleeves with four M8 threaded rods. The length of rods
must be adjusted so that they will be positioned approx.
15–20 mm under the inner surface of the ceiling
mounting frame. Install the ceiling mounting frame
approx. 35–55 mm below a suspended ceiling.
The ceiling mounting frame must not be used as
part of a support structure for the ducts
, the duct
support must be sufficient even without the support
effect provided by the ceiling mounting frame.
Secure the locking hooks in mounting openings on
the ventilation unit’s top side by means of pop rivets.
Position the hooks so that the sharp point is facing the
rear side of the ventilation unit.
The hooks must absolutely not be secured with
rivets directly above the ventilation unit.
The points of the hooks face the rear part of the ventilation
unit and they are to be slipped into the unit’s notches before
you secure them with rivets.
Hang the ventilation unit up in the mounting frame
so that the rear of the unit engages in the suspension
plate. Lift the ventilation unit up against the ceiling
mounting frame so that the locking hooks on both sides
engage into position. The unit is firmly secured if the
screw heads on the front part of the ceiling mounting
frame return to their original positions. The ventilation
2.1 Ventilation unit’s installation site
The temperature in the space where the unit will be
installed must be more than +10 °C. The ventilation unit
can be installed in a machine room, laundry room, store
room, etc.
The ventilation unit can also be mounted in the kitchen
above the cooker. Swegon CASA Jazz cooker hood can
be connected directly to/below the ventilation unit.
Due to the risk of disruptive noise, the ventilation unit
should not be installed on the wall towards the living
room or bedroom.
Make sure it is easy to access the power and control
cables as well as accessories.
The ventilation unit can be mounted either on the wall
with a wall mounting bracket included in the supply or
on the ceiling with a ceiling mounting frame which is
available as an optional extra.
The unit should be mounted as near as possible to a
wall or ceiling. The space between the ventilation unit
and the wall/ceiling must be insulated to prevent the
transmission of sound through the wall behind the unit
to the adjacent room.
2.1.1 Wall mounting
A wall mount is supplied together with the ventilation
unit.
If it is a question of a light partition wall, the wall must
be reinforced with horizontal studs that support the
weight of the ventilation wall. In addition, Swegon also
recommends that the wall be insulated with mineral
wool or similar insulation for preventing sound from
propagating to other rooms.
Screw the wall mount firmly in horizontal position onto
the wall where a wall stud will support the weight
of the unit. Lift up the ventilation unit onto the wall
mounting bracket so that the ears on the bracket
engage in the corresponding notches at the top on the
backside of the unit.
The door of the ventilation unit and the fans can be
dismantled to facilitate lifting the ventilation unit. See
the ”Servicing” Section.
2. Installation
1
2
1. Horizontal stud for the ventilation
unit’s mounting bracket
2. Acoustic insulation
1
2
3
1. Insulated wall
2. Horizontal stud
3. Wall mounting
bracket
Wall mounting bracket’s dimensions
299
299
505
68
54
14
505
