SWEBAD Hemavan 100, Manual

Page: 38 / 64

38
INSTALLATION
ENG
2.2. BASIN
2.2.1. EVERYDAY CARE
• It is recommended to clean the basin immediately after every use. Rinse thoroughly with warm water and dry with soft and
dry cloth to avoid water stains.
• Washing with soap or hand dishwashing liquid and water is usually sufficient to remove surface dirt or stains.
• Upon need of thorough cleaning wide variety of bath cleaning sprays sold with safety labelling allowing the cleaning of such
surface or commercially available solid surface cleaners are effective.
• Drying is an important step, preventing a build-up of limescale, soap film or cleaning residue, which can create the
appearance of light scratches over time.
2.2.2. PREVENTING DAMAGE
Some chemicals are not compatible with Solid Surface materials, and could permanently harm the surface beyond repair.
Avoid surface contact with:
• Strong chlorinated solvents: Chloroform, Chlorobenzene
• Nail polish removers, paint removers, solvents: Methylene Chloride, Acetone, Turpentine, Ethyl Acetate, Furfural
• Very strong acids: Concentrated Sulfuric Acid, Hydrochloric Acids, Acetic Acid, Chromic Trioxide Acid, Formic Acid, Glacial
Acetic Acid, Hydrofloric Acid, Nitric Acid, Phosphoric Acid, Sulphuric Acid, Trichloroacetic Acid
• Ketones
• Cresol, Phenol (Phenols)
• Dioxane (Ethers)
• Giemsa, Hexaphene, Luralite, Photographic Film Developer
• Acid drain cleaners, Aqua Regia Cleaner, stove and toilet cleaning products
• Other unknown chemicals or chemicals not allowed for cleaning for Solid Surface materials
• Salts, oils, milks, colourants, and other chemical bathwater additives. Surfaces exposed to these chemicals should be
promptly flushed with water; contact may cause spots that may require extensive repairs. Remove nail polish with a non-
acetone-based nail polish remover and flush with water.
• Avoid subjecting Silksten Solid Surface to extreme hot temperatures or hot objects. Solid Surface has excellent heat
resistant properties. However, placing heat-generating appliances or hot objects, can damage the surface.
• Never cut on a Solid Surface surface to avoid scratching the surface.
• Avoid dropping heavy and/or sharp objects on the surface as it may harm the surface or altogether break the product beyond
repair.
2.2.3. CLEANING OF DRAINAGE SYSTEM
The drainage system is assembled from standard plastic drain components. To remove a possible clog up a standard
household drainage cleaning agent may be used that is allowed for such purpose. Remove the drain cover by pull it up/off and
pour carefully the cleaning agent to the drain tube not spilling the pipe cleaner over product surfaces.
2.2.4. REPAIRS
For possible need of repair of the product please contact the dealer for further information. Minor damage that may
accidentally occur is most often repairable.