INSTRUCTION BOOKLET
INSTRUCTION BOOKLET
10
DUST BAG
The dust bag (15) fits in the dust extractor port. For efficient operation, empty the dust bag when it is no more than half
full. This allows better air flow through the bag.
Setting the Table Square with the Blade
1.
Make sure that the electrified plug is removed from the power point.
2.
Push the saw arm (5) down to its lowest position and engage the release knob (6) to hold the saw arm in the
transport position
3.
Loosen the mitre locks (25)
4.
Rotate the table (21) until the pointer is positioned at 0 degrees
5.
Tighten the mitre locks (25)
6.
Loosen the bevel lock (16) and set the saw arm (5) at 0 degrees bevel (the blade at 90 degrees to the mitre table).
Tighten the bevel lock (16).
7.
Place a set square against the table (21) and the flat part of the blade.
NOTE!
Make sure that the square contacts the flat part of the saw blade, not the teeth. Rotate the blade by hand
and check the blade-to-table alignment at several points.
8.
The edge of the set square and the saw blade should be parallel.
9.
If the saw blade angles away from the set square use an 8mm wrench or adjustable wrench to loosen the lock nut
securing the 0 degrees bevel adjustment screw (34). Also loosen the bevel lock (16).
10.
Adjust the 0 degrees bevel adjustment screw (34) using a wrench to bring the saw blade into alignment with the
square.
11. Loosen the screw holding the pointer of the bevel scale (17) and adjust the position of the pointer so that it
accurately indicates zero on the scale. Retighten the screw
12. Retighten the bevel lock (16) and the lock nut securing the 0 degrees bevel adjustment screw (34)
NOTE!
The above procedure can also be used to check the angle of the saw blade to the table at 45 degrees bevel
angle. The 45 degress bevel adjustment screw (33) is on the opposite side of the saw arm.