1.1.4 FCC ID:
The FCC ID for the Tile is
2AVE9-TILE01
. All manufacturers integrating the Tile into their
products are advised to provide a physical or e-label stating “Contains FCC ID:
2AVE9-TILE01
”.
1.1.5 Part 15 Subpart B Disclaimer:
The final host product requires Part 15B compliance testing with the modular transmitter
installed.
1.2 ISED Compliance
1.2.1 ISED RSS-Gen Notice CAN ICES-3 (B)NMB-3(B):
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1) l’appareil ne doit pas produire de brouillage;
2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
1.2.2 IC ID:
The IC ID for the Tile is
25817-TILE01
. All manufacturers integrating the Tile into their products
are advised to provide a physical or e-label stating “Contains IC ID:
25817-TILE01
”
1.3 RF Exposure Guidance
In order to comply with FCC / ISED RF Exposure requirements, this device and antenna must
be installed to provide at least 29 cm separation from the human body at all times.
Afin de se conformer aux exigences d'exposition RF FCC / ISED, cet appareil doit être installé
pour fournir au moins 29 cm de séparation du corps humain en tout temps.
June 2020
Swarm Tile Manual - Rev 1.00
8/63
