28
sWaP Rebel
user guide
www.s-w-a-p.co.uk
Contents
Important safety information
Exposure to radio frequency (RF) signals
Your sWaP Rebel contains a radio transceiver. When it
is on, it sends and receives radio frequency (RF) signals.
When you communicate using your sWaP Rebel, the
system handling your call controls the power level at
which it transmits.
Your sWaP Rebel is designed to comply with local
regulatory requirements in your country concerning
exposure of human beings to RF energy.
Operational precautions
To ensure that your sWaP Rebel continues to serve you
reliably, look after it as you would any other valuable
item and also follow these guidelines:
Apart from the battery cover, do not open your sWaP
Rebel or tamper with the internal circuitry as this could
cause damage and will void your warranty.
Your sWaP Rebel is NOT waterproof. Avoid contact with
water. If your sWaP Rebel becomes wet, switch it off
and remove the battery. Carefully and completely dry
out your sWaP Rebel and the battery before attempting
to switch it back on.
Do not press hard on your sWaP Rebel as this may
cause damage to the touch screen.
Do not expose your sWaP Rebel to direct sunlight,
extremely high or low temperature, dusty/sandy
conditions or very humid environments for extended
periods of time as this may cause damage to the screen
and/or internal circuitry.
Do not throw, beat or vibrate your sWaP Rebel in a
manner that might damage the external casing, the
sensitive touch screen or internal circuitry.
Do not use any corrosive chemical products or scouring
pads to clean your sWaP Rebel. Use only soft wipe to
clean it.
If your sWaP Rebel is lost or stolen, notify your network
provider to initiate the cancellation of the SIM Card.
You may be asked for the IMEI number which is printed
inside the battery compartment and also on your sWaP
presentation box. Write this number down in advance
and store it in a safe place.
RF energy interference/compatibilities
Note: Nearly every electronic device is susceptible
to RF energy interference from external sources
if inadequately shielded, designed, or otherwise
configured for RF energy compatibility. In some
circumstances your sWaP Rebel may cause interference.
Facilities and hazardous areas
Turn off your sWaP Rebel in any facility where posted
notices instruct you to do so. In certain cases it may be
sufficient to place your sWaP Rebel into Flight Mode
to disable the radio transceiver circuitry. However, in
certain instances, switching off power altogether may
be the only solution.
Hospitals and aircraft
Hospitals, health care facilities and aircraft regularly
use equipment that is sensitive to external RF energy.
Switch off your sWaP Rebel when instructed to do so or
place it into Flight Mode.
Flammable liquids
Adhere to all warning signs in areas where flammable
liquids are present, such as petrol/gas filling stations.
Switch off your sWaP Rebel before entering such an
area.
Medical devices
Pacemakers
Pacemaker manufacturers recommend that a minimum
separation of 6 inches (15 centimetres) be maintained
between any mobile phone and a pacemaker.
People with pacemakers should:
• When it is switched on, always keep your sWaP
Rebel more than 6 inches (15 centimetres) from the
pacemaker.
• Never carry your sWaP Rebel in a breast pocket.
• Use the ear opposite the pacemaker to minimise the
potential for interference.
• Stop using and turn off your sWaP Rebel immediately if
there is any reason to suspect that interference is taking
place.
Hearing Aids
Some digital wireless phones may interfere with some
hearing aids. In the event of such interference, you
may want to consult your hearing aid manufacturer to
discuss alternatives.
Other Medical Devices
If you use any other personal medical device, consult
the manufacturer of your device to determine if it is
adequately shielded from RF energy. Your physician
may be able to assist you in obtaining this information.
