SwanStone Swan DWP-369601, Manual

Page: 8 / 20

5. Place the panel, finished side facing up, on a flat surface.
Using a pencil, lightly mark the center of the back panel.
6. Take several measurements, bottom-to-top, from the
center line to each wall surface. These measurements will
ensure the back panel fits the exact contour of the two.
side walls.
7. Transfer the measurements onto the front surface of the
back panel.
Note
: The back panel can be cut
slightly
smaller than the
opening because the side panels will cover any small
gap (less than 1/4 inch).
Cutting the side panel to precisely fit the back wall is not
necessary if a corner molding, supplied in some kits, is
used. This corner molding will cover gaps up to 1/2”.
WARNING
Dust Hazard
When cutting or drilling the Swanstone product,
use a dust collection method which prevents
dust particles from going into the air. Always work in a well-
ventilated area. To keep the area well-ventilated, open
windows and use exhaust fans. Always use an OSHA
approved dust mask when cutting, drilling, or sanding
Swanstone products.
8. Place pieces of masking tape over the area where the
saw contacts the finished surface of the panel.
9. Cut the panel using a circular saw with a 60-80 tooth
carbide blade or a saber saw with a bi-metal blade (14
teeth per inch).
IMPORTANT NOTICE
Any cutout for accessories should have rounded corners
(sharp corners can promote stress cracks).
10. Dry fit the back panel, and make any necessary
adjustments. Temporarily secure the back panel to the
wall in order to properly fit the front and rear panels.
IMPORTANT NOTICE
DO NOT force a panel to fit a bowed or curved wall as it may
break; furthermore, the resiliency of the panel can break the
silicone bond to the wall surface.
Swan 8 800-325-7008
Installation Procedure