OPERATING INSTRUCTIONS
Cleaning the HEPA Dust Cup Filter
IMPORTANT, Please Note:
The Washable “Tap
Clean” Anti-microbial HEPA Dust-bin Filter will
stop most dust particles and airborne allergens
from re-entering the air you breathe.
The Anti-microbial HEPA Dust-bin Filter will
quickly accumulate many fine dust particles
within the white filter folds and will eventually
reduce your suction power if not cleaned
properly. Clean the Anti-microbial HEPA Filter
after each use as described in this section.
1. To remove the Anti-microbial
HEPA filter: With the dust-bin
removed, unclip the filter cover
and lift the filter from the
dust-bin. (Fig. 9)
2. Vigorously "Tap Clean" the Anti-microbial
HEPA dust-bin filter on a hard surface until
no more dust is observed falling out.
(Fig. 10)
To assist cleaning the
Hepa filter pleats you can
use the rotating beater.
This is positioned on top
of the filter.
(Fig. 11)
After taping clean, the
HEPA filter can be rinsed
through by running it
under a tap in tepid water.
(Fig. 12-1)
We recommend washing
the filter once a month
or when suction appears
reduced.
Always allow 24 hours
for drying before
refitting to the vacuum.
Please Note
: The white Anti-microbial HEPA
filter will discolour over time - This is NORMAL
and will NOT affect the performance of the filter.
To obtain optimum performance
:
Before each use you must ensure the dust-bin is
empty and that the Anti-microbial HEPA filter is
clean and free from dust and hair.
Cleaning the HEPA Filter Frame
1.Before replacing the Anti-microbial HEPA filter:
Remove the filter frame by placing your hand on
the frame from within the dust-bin and twisting
clockwise to unlock.
Rinse the frame in lukewarm water by just
running it under the tap to remove any dust that
has adhered to the frame. (Fig. 12-2) Do
NOT
place in dishwasher.
3. Make sure that the filter frame is
completely dry before replacing.
4. Refitting is the opposite procedure to
removal. Please ensure the frame locks
in position. It will click shut.
Cleaning the Secondary Filter
1. Underneath the Anti-microbial HEPA filter is a
secondary filter. This foam filter can be cleaned
by washing / rinsing in lukewarm water. (Fig. 13)
We recommend washing it when you are
washing / rinsing your HEPA filter.
Always
allow the secondary filter to
air dry for
24 hours
before refitting into the vacuum. Never
run the vacuum without the secondary filter in
place.
Fig. 13
Fig. 12-2
Fig. 11
Fig.10
Fig. 12-1
Fig. 9
7
