The Night Watch camera is designed for use with any DVR, VCR, Security Monitor, TV or
computer with a video capture card. The camera can be used indoors or outdoors. The Night
Watch camera can be used for a variety of purposes including monitoring callers at the door,
keeping your car, yard, shop, children’s play area.
1.
2.
3.
Night Watch Camera with Stand and fixed cable.
12Volt DC Power Adaptor (adaptor design varies depending on country).
BNC male to RCA female Gender Changer
Your
is designed to transmit high quality images to your Security Device
or Television and is operated by mains power. To help guide you through the process of setting
up the
, we have outlined the steps and numbered each of the
components required in the diagram below.
Night Watch Camera
Night Watch Camera
1.
2.
3.
4.
5.
Once you have chosen the best position for the camera, switch the
power to the camera off, and unplug the power lead from the camera.
When mounting the Night Watch Camera to your ceiling or wall,
please ensure that you rotate the camera so that at the top of the
camera lens is ‘up’, otherwise you will find that your pictures are
displayed upside down. (see diagram)
Hold the camera base in the position you wish to fix it, and mark the
holes with an appropriate pen or pencil. Once this is done, remove the
stand and drill a hole with the appropriate drill bit for the material you
are mounting your camera to and the screws you are using.
Run the camera cable back to the TV/VCR, any holes that you drill
need to be at least 14mm in diameter to allow the connectors to pass
through.
Reconnect the power lead to the camera and switch the camera
power back on.
1
4
VCR, TV or MONITOR
OUT
IN
VIDEO
VIDEO
AUDIO
AUDIO
VIDEO IN
2
2
3
These step by step instructions are provided for you to enable a quick and simple installation of
your camera. Please refer to the diagram at the bottom of the page for component
identification details.
Video BNC Female
DC Power Jack
1b
3
4
3
RCA Video In
2a
2
1a
2
Step 1:
Step 2:
BNC Female
BNC Male Adaptor
RCA Male Gender Changer
BNC Male Adaptor
Step 3:
Power Connector
power adaptor
Step 4:
power adaptor
Step 5:
TV
AV
VCR
VCR
A/V
Input
TV
VCR
instructions
VCR
TV
A/V inputs.
Note:
At the end of your Night Watch Camera camera cable you will find two plugs:
•
•
Plug the
(
) into the
( ) and turn the outer ring to
lock the connectors. Plug the
( ) into the opposite end of
the
( ) and then into the
socket on your TV or VCR
(usually located at the back).
Connect the
(
) at the end of the
( ) in to your
Night Watch Camera’s DC Jack (
).
Plug the
( ) into the mains power point on your wall and switch on if
required.
You will then need to switch the
to the
channel to view the camera. To record the
Night Watch Camera’s images to your
, you will need to turn the
to the
selection and turn your
onto the channel you would normally use to view a
tape or movie on your
. Please read the
for your
or
for
more information on using their
The Night Watch Colour Camera will automatically change to a black & white image using
the Infra-Red LEDs when available light is too low to support a clear colour picture.
BNC Female
DC Jack
DC POWER
CONNECTOR
2a
1b
CAMERA
with Stand
POWER
ADAPTOR
2
1a
3
4
1
Installation Instructions
How to connect the Night Watch Camera to your monitoring device
Contents and Parts Identification
Mounting the camera on your wall of ceiling
How to connect the Night Watch Camera to your monitoring device
2
3
