1
This guide has been designed to help you connect
the cables and install your HD Dome camera at
your desired location. To set up and configure
the camera so you can view it on your Swann
NVR-7300 or NVR-7400 please use the guides
that came with your NVR or search for them at
http://support.swann.com/ and follow the steps
for adding cameras using the on-screen menu.
Important note
- All jurisdictions have specific
laws and regulations relating to the use of cam-
eras. Before using any camera for any purpose,
it is the buyer’s responsibility to be aware of all
applicable laws and regulations that prohibit or
limit the use of cameras.
Important safety instructions
1)
Make sure the camera is fixed correctly and
stable if fastened in place.
2)
Do not operate if wires and terminals are ex-
posed.
3)
This camera can only be used in combination
with Swann’s NVR-7300 and NVR-7400 HD net-
work video recorders.
4)
The reset button is used to perform a factory
reset. Disconnect the Ethernet cable, hold down
the reset button then connect the Ethernet cable.
Keep holding the reset button for 20 seconds then
release. The NVR will take a short time to detect
and display the camera after it has been reset.
Warning
- Modifications not approved by the party
responsible for compliance could void user’s au-
thority to operate the equipment.
Introduction
