13
16. Area Set
Move the cursor to Alarm Set, then push the
ENTER
button
and the alarm setup window will
appear, as illustrated as below. Push the
UP
,
DOWN
,
LEFT
and
RIGHT
button to move the
cursor and push the
ENTER
button to change
from detection
ON
to
OFF
. Push
and hold
ENTER
to change all values to the same as
the area you have selected.
If the area marker icon is set to yellow this area is monitored for motion detection, and if the
icon is grey motion sensing is disabled for that area.
17. Schedule Set
When the cursor moves to Schedule Set, please push enter button, the schedule set window
will appear, which is illustrated as below.
You change the recording schedule during a day (24-hour period) using this option.
0-24 stands for 24 hours of a day, each hour can be set to one of three states:
T (time)
,
A (alarm)
,
- (disable)
.
(T)
This period is time scheduled, when the DVR4Net is in scheduled state (push the
Schedule
button), this period will record automatically.
(A)
This period is alarm scheduled, when the DVR4Net is in scheduled state (push the
Schedule
button), this period will record automatically when there is an alarm input (including
both motion and sensor alarms).
(-)
This period will not record unless you push the record button.
Push the
LEFT
button or
RIGHT
button to move the cursor, then
push “
+
” or “
-
” button to
change the value. Push the
ENTER
button to set all the values the same as selected one.
Note: Manual record mode and schedule record mode (including motion detection
record mode, sensor record mode and time schedule record mode) cannot be used at
the same time. Once the user selects Schedule record mode, manual record mode will
be disabled. If the user selects manual record mode, schedule record mode will be
disabled.
26
11. Zoom Operation
Push zoom button, the DVR will be in zoom mode, which is illustrated as below. Push
upward, downward, leftward or rightward to move the zoom area, then push enter button to
zoom, push zoom button again to cancel zoom operation.
12.PIP Operation
Push PIP button, the DVR will be in PIP mode, which is illustrated as below.
You can push the
PIP
button again to change
PIP
mode Press and hold the
PIP
button to set
each
PIP
picture. Press and hold the
PIP
button, until one channel name is highlighted yellow,
then push the
LEFT
and
RIGHT
button to change selected channel, push
the
+
and
-
button
to change this channel's picture, then push
ENTER
.
